MINI DIAMOND POINT 4.8MM CYL. 2.4MM SHANK
The tip of the bit is coated with diamond particles to allow it to be used for engraving, carving and smoothing.
The diamond point can be used on:
- Semi-precious stones
- Allows for compact and accurate engraving
- Fits standard collets
- Wide range available - Tools for every job
|Cylinder diameter||Ø 4.8mm|
|Shank diameter||Ø 3.2mm|
The shank is securely locked in place by fitting it in the corresponding collet or making use of a keyless chuck.
Most rotary tools have the benefit to adjust the rotation speed. Many tool bits that fit in rotary tools have a maximum speed setting. This can normally be found on the packaging.
All materials react differently to speed and will need the tool bit to rotate slower. It is recommended to start using accessories on the slower speed first, before increasing the speed as needed.
The diameter of the tool bit fitted also determines the rotation speed. The larger the diameter, the slower the speed. If the speed is set too high, it could bend the shank/shaft resulting in injury.
|consider safety for your health and the people around you|
General safety suggestions:
It is advisable to always have the following items nearby and in a good condition