HARD FELT POLISHER 14MM.REVERSE TAPER.SH.2.35MM
The hard felt polishing point can be used for polishing metals, glass, ceramics, precious metals, stone and plastic.
Use the correct polishing paste for the desired material and finish:
- M4905 - Pre-polishing paste to remove oxidations and light surface imperfections (pink)
- M4910 - Final polishing paste to remove dullness (white). Apply after using the pre-polishing paste.
- M4915 - Polishing paste for copper, brass and bronze (red).
Do not mix polishing pastes on the same polishing point
QTY: 1
| Description | Specification |
| Diameter | Ø 14mm |
| Shape | Reverse taper |
| Shank diameter | Ø 2.35mm |
The shank of the rotary cutter is securely locked in place by fitting it in the corresponding collet or making use of a keyless chuck.
Rotation speed:
Most rotary tools have the benefit to adjust the rotation speed. Many tool bits that fit in rotary tools have a maximum speed setting. This can be found on the packaging.
All materials react differently to speed and will need the tool bit to rotate slower. It is recommended to start using accessories on the slower speed first, before increasing the speed as needed.
The diameter of the tool bit fitted also determines the rotation speed. The larger the diameter, the slower the speed. If the speed is set too high, it could bend the shank/shaft resulting in injury.
| consider safety for your health and the people around you | |||
General safety suggestions:It is advisable to always have the following items nearby and in a good condition
|
|||
 |
 |
 |
 |
|
Wear Gloves
|
Eye Protection
|
Hearing Protection
|
Dust Mask
|