CUTTING DISC MULTI PURPOSE 230 X 2.0 X 22.2MM FOR STEEL SS PVA STONE

Click Image for Gallery

Cutting disc for masonry, steel, PVA and stainless steel

Multi purpose cutting disc 230mm

Compatible with 230mm dia. angle grinders.

Designed for cutting steel, PVA and Masonry.

A steel cutting disc is used for:

Mild steel cutting
Car body panel work
Stainless steel cutting
Metal cutting
Wall chasing
Brick cutting
Stone cutting
PVA cutting

Always make use of the necessary safety equipment when using machinery or powertools!

Write a review

Your Name

Your Review

Note: HTML is not translated!

Rating Bad Good

Captcha

Please complete the captcha validation below

Description	Value
Size Ø	230mm
Blade thickness	2.0mm
Bore	22.23mm
Max rpm	6,650 rpm

What is a grinding wheel?

A grinding wheel is a tool used to grind down, polish or cut material such as metal or glass. Like sanders, it uses abrasive grains to wear away the surface in minute particles. Grinding actually sharpens the wheel by breaking those grains and creating new sharp points.

Grinding metal

What is a grinding wheel made of?

A grinding wheel is made from several chemical and mineral ingredients. The formula varies according to what the wheel will be intended to grind, polish or cut.

For metalwork, they use abrasives that are aluminium oxide based. For cutting cement, stone and other non-metal objects they use abrasives that are silicon carbide based.

Even within those two categories, the formula differs between say, a wheel designed for hard steel versus one designed for soft steel. Computer programmed scales automatically weigh the various ingredients, including additives such as iron oxide (for wheels that cut or grind iron) and the mineral Cryolite (which lubricates the abrasives). Powdered and liquid resins bond all these ingedients together.

The grinding disc is then reinforced with fibre glass and a galvanised steel ring goes into the centre of each wheel. The steel ring protects the shaft that spins the grinding wheel.


When using grinders and wire brushes
When using grinders and wire brushes one should take care of the following: Start with a tidy work place. Tripping over cables and climbing over obstacles is not good practice while working. Grinders generate noise and these high frequency sounds will harm your hearing. Wear Earmuffs Use a face shield to avoid sparks and metal pieces entering your eyes Protect your lungs by wearing a dust mask Wear gloves to protect your hands against sharp edges and hot surfaces Always observe in which direction the sparks fly. Void fires! Keep visitors at a safe distance Always unplug and switch off equipment when leaving the workplace.

Be careful and observe	Wear a faceshield when grinding	Protect you lungs. Wear a dust mask	Protect your hands against cuts & heat